Oriental Research & Development Co.,Ltd.

FPGA Evaluation board FT245-EP1C6

▲FT245-EP1C6

▲IO_MEMORY_TEST_Program

▲IO_TEST_Program with VB6 source

\74,520

FT245-EP1C6 is Cyclone series FPGA of the Arutera corporation and the FPGA evaluation board which mounts the FTDI corporation USB controller. As the general-purpose controller to use, being to become the circuit kind of constitution which it can receive, the survey instrument, please use by all means in the jig and the controller etc. of the small lot not only the evaluation of FPGA. USB device driver, control software, the sample circuit of FPGA (Velilog description) standard attachment. It can construct the system which cooperates with PC easily

・I/O banks are driven with 3.3V or 2.5V that the designer defines (the bank 1 and 2 are 3.3V only).
・LVDS super speed communications are
available via an RJ45 connector.
・EPC has two banks of 512KSRAM, the FPGA may access one of the
memories while the host PC is accessing the other.

Size: 130 x 110mm
FPGA chip: EP1C6Q240C8
FPGA configuration: AS and JTAG
USB controller: FTDI FT245BM
USB port: Type B
Configuration ROM: EPCS1
RAM: Two 8bit-512K(70ns) SRAM’s
User I/O: 5 I/Os in Bank 1, 43 I/Os in Bank 3 and 36 I/Os in Bank4
Operational parts: A 16x2 LCD, 4 push switches, 4 dipswitches, a buzzer and4 LED
Clock: A built-in 24MHz crystal and acircuit
pattern for user crystal
Power: 5V DC (USB bus power or DC jack)

QuartusII Web Edition” is available at the Altera Web site without charge.http://www.altera.co.jp/
A cable “ByteBlaster II” for down loading is required.。DL-MV2

USB device driver
The latest device driver is available from the FTDIWeb site at
http://www.ftdichip.com/

＜TESTProgram＞
As for this board when shipping the test circuit which used USB interface is already programmed.
The read-write of memory on this board, it can control the indication of the LCD panel, on off of the buzzer and on off etc. of LED from the personal computer the USB driver which is recorded in attachment CD-ROM, by installing the IO_MEMORY_TEST program or the IO_TEST program.
As for the IO_TEST program it meaning that the source code of VB6 has been attached as a one for reference of the control program, please refer collectively.